--------------------------------------------------------------------------------

DESCRIPTION:

Conductor: Tinned, annealed copper per ASTM B33. Class B stranding per ASTM B8.

Sizes: #18 AWG – #16 AWG

Insulation: Extruded flame-retardant ethylene propylene rubber (EPR).

Pair: Conductors twisted together with a drain wire and aluminum mylar shield.

Cable: Shielded pairs cabled together with fillers as needed to form a round core. An overall aluminum mylar shield and drain wire is applied over the core.

Color Code: Pairs are black & white with pair number printed on the white conductor.

Jacket: Flame-retardant, sunlight resistant,
Chlorinated Polyethylene (CPE).

Options: Available with class K stranding per ASTM B174.
Available with class H stranding per ASTM B173.
Available with bare copper conductors.

Applications / Installation:
For use as a 600 volt, multi pair instrumentation cable where flame retardance, and moisture/chemical resistance is critical. Cable can be installed in free air, in raceways or direct burial. The cable is also approved for wet or dry locations as well as Class 1 Division II industrial hazardous locations per NEC 501-4(b) for (UL) Type tray cables (TC).

Features and Benefits:
Temperature rating of 90°C wet or dry. Insulation provides excellent electrical, thermal, and physical properties, excellent flame resistance and resistant to crush, compression, cuts and heat deformation. Also conductor insulation provides good low temperature (-40°C) cold bend characteristics.

Approvals:
Insulated Conductor: – VW-1
Cable: – Direct Burial
UL Type TC, 90°C Wet or Dry, 600V
Passes UL 1277 Flame Test (70,000 BTU/hr)
Passes IEEE 383 Flame Test (70,000 BTU/hr)
ICEA S-82-552, 90°C Wet or Dry, 600V
Passes IEEE 1202 Flame Test (70,000 BTU/hr)
Passes ICEA T-29-520 Flame Test (210,000 BTU/hr)

FREP/CPE Instrumentation Cable - Shielded Pairs